Aluminum Sliding Window Replacement

  • 2018-10-14

  • admin

General process of door and window removal:
Before aluminum sliding window replacement begins, the person in charge of the aluminum sliding window installation needs to carry out comprehensive safety and technical disclosure to the installation workers. Enable the installer to grasp the various precautions that should be paid attention to during the construction of the aluminum sliding window.

1, first remove the aluminum sliding window fan
The aluminum sliding window fans should first be removed with tools such as a screwdriver and a hammer. During the disassembly process, one person should be disassembled and one person is responsible for the stability of the aluminum sliding window. After the aluminum sliding window is removed, it should be handled gently. It is forbidden to push down at high altitude.

2, remove the aluminum sliding window frame
After the aluminum sliding window is removed, the aluminum sliding window frame can be removed. Generally, it is necessary to first cut the sealant on the inside of the aluminum sliding window frame with a blade. If the aluminum sliding window are connected with the wall by using expansion bolts, the expansion bolt can be directly removed by a screwdriver; if the expansion bolt is rusty, it can be hammered. If it is connected by a connecting piece, use the impact drill directly; if the window frame is difficult to remove, use a hacksaw to saw and remove the frame against the wall.

3, clean up the repair aluminum sliding window opening
When the aluminum sliding window are disassembled, it may cause certain damage to the aluminum sliding window openings. If it is not treated, it is not conducive to the installation of new aluminum sliding window. Therefore, after the aluminum sliding window are disassembled, it is necessary to check whether the size of the hole is correct, whether it is horizontal and vertical, and to treat the hole that does not meet the requirements.



General process of aluminum sliding window installation:
1, fixed bracket
2, styrofoam
After the aluminum sliding window are adjusted, you need to make styrofoam to fill the gap between the aluminum sliding window frame and the wall. After the foaming rubber is cured, the excess styrofoam is cut off.
3, install aluminum sliding window fans and other accessories
After fixing the aluminum sliding window frame, install the aluminum sliding window fan and other accessories. Be careful when installing.
4, sealant
After the styrofoam is finished, apply a sealant evenly around the aluminum sliding window frame to prevent rainwater from penetrating into the room from the installation gap between the aluminum sliding window and the wall.
The general procedure for installing aluminum sliding window is to first install the frame, then check for stability, and then fill the gap with styrofoam. Then install the window sash and other accessories, and finally sealant to prevent water seepage.

Contact us

Competent advice tailored to your needs Good investments require good information. We will be pleased to offer you individual advice. Please complete the contact form below.

Address

No.5 Songxing Road Songgang Shishan Town,
Nanhai District, Foshan City, Guangdong Province, China

Phone

0757-85225366

Whatsapp

+86 15820600599